Hold your hair at a 45 degree angle your hair if you're going for a bob. The outer edges should fall just on the outside of your eyes. If you must go shorter, repeat the process moving your fingers up just a little bit at a time.
Measure The Upper Layer Against The Bottom One While Cutting It.
Brush your hair again and tie another elastic band at the point where you want to cut your hair. Pull your fingers down the hair at exactly the same pace. Measure off the hair accordingly and hold the hair straight in between your fingers.
Gather Hair Between Your Index And Middle Finger At The Bridge Of Your Nose And Point Cut Below Your Fingers.
Add a thin strand from the bottom layer to it. Pull this section straight up. Put another rubber a few inches below the first one.
Bring Your Hair To The Front And Snip At.
Make sure that the tail is smooth and crisp, and that all the hair is inside the rubber. Pull your hair back, and do a low ponytail. Place two fingers on either side of your hair above the second elastic band.
Cut In A Straight, Even Line With No Angling If You Want A Blunt Cut.
Continue shaving vertical sections up to the guideline until there is no hair below the guideline. Move about half of this hair to the right side. Section the hair into three parts with the center falling down the back.
